I will design pcb iot and embedded systems layouts in kicad and eagle

Need a reliable PCB design for your IoT or embedded system that goes straight to production without costly re-spins? I deliver clean, manufacturer-ready PCB layouts using KiCad, Altium Designer, and Eagle engineered to pass DRC on the first review.

   Whether you are building a smart sensor node, a wireless IoT gateway, an ESP32/STM32-based device, or a custom embedded controller, I translate your schematic into a fully optimized board layout with signal integrity, EMI/EMC control, and design-for-manufacturability (DFM) built in from the start.

What you get with every PCB design order:

• Schematic capture and full
• PCB layout
• (single, double, or multilayer)
• DRC-clean Gerber files, drill files, and BOM ready for your fab house
• Pick & Place file for SMT assembly
• 3D board preview (KiCad / Altium)
• DFM review component spacing, trace widths, thermal relief, and via sizing
• Signal integrity checks for high-speed lines (I2C, SPI, UART, USB)

I work with a wide range of IoT microcontrollers and modules including ESP32, ESP8266, STM32, Arduino, nRF52, Raspberry Pi CM4, and LoRa/LoRaWAN modules. Power supply design, battery management circuits, and RF antenna placement are all within scope.