Sfoglia categorie
Esplora
Fiverr Pro
Italiano
$
USD
I will design and install cctv, data, pa, access control, and elv low voltage systems
Licensed Engineer
Permit delays, unclear wind pressures, and incomplete structural documentation can hold up a project. I provide engineering-focused Florida wind load, design pressure, window & door, storefront, and e...
Informazioni su questo servizio
Is your home wiring running blind, tangled, or completely unplanned? I design and install structured low voltage systems that actually work the way your home demands.
I handle end-to-end ELV installation covering:
- Structured data cabling Cat6/Cat6A, rack termination, patch panels
- CCTV systems camera placement, DVR/NVR setup, remote viewing configured
- Access control card readers, electric locks, door controllers, fail-safe wiring
- PA systems amplifier zoning, speaker placement, volume control per room
- Intercom & video doorbell integration into your existing entry points
I don't guess cable routes. I read your floor plan, map the signal paths, and deliver clean conduit runs with labeled terminations the way a licensed low voltage technician does it.
Every project includes:
- Full system schematic before work begins
- Proper grounding and shielding for interference-free signal
- Test results and hand-off documentation
Whether you're building new, renovating, or upgrading outdated wiring I scope it correctly from the start so you never pay twice.
Message me with your floor plan or project size. I'll tell you exactly what you need.
Tipo di edificio:
Residenziale
•
Commerciale
•
Industriale
Software:
Bluebeam
•
PlanSwift
•
Microsoft Excel
Preferenza per lo stile di consegna
Informa il freelance di eventuali preferenze o preoccupazioni relative all'uso di strumenti di IA nel completamento e/o nella consegna dell'ordine.
Altri servizi della categoria Ingegneria edilizia offerti da me
FAQ
Do you just provide a design, or do you handle the full installation too?
I handle the complete workflow, system design, cable routing, device installation, termination, labeling, and final testing. You won't be handed a schematic and left to figure out execution. Every package includes a floor plan markup before work begins, so you know exactly what's being installed.
My home is already built. Can you work with existing walls and conduit?
Yes, retrofit installs are the majority of what I do. I assess existing conduit, wall cavities, and cable paths before proposing a route. Where new conduit isn't possible, I use surface raceway or existing pathways to keep the install clean.
What do you need from me to get started?
Send me your floor plan (hand-drawn is fine), the systems you want installed, and the number of rooms or entry points involved. That's enough for me to scope the job, confirm the right package, and give you a delivery timeline.
Will the CCTV and access control systems work together, or are they separate?
They're integrated by design, not bolted together after the fact. I wire CCTV, access control, and intercom from the same backbone so they share conduit runs, a common power source where applicable, and a single control point.
What if I need changes after the work is delivered?
Revisions within the original scope are included in every package. If you want to add a device, extend a cable run, or adjust a camera angle after sign-off, that falls under a small scope addition, I'll quote it transparently before touching anything.
