Sfoglia categorie
Esplora
Fiverr Pro
Italiano
$
USD
I will design pcb schematic and layout in kicad, easyeda, altium and eagle
Discord Telegram Community Manager, SharePoint Microsoft 365 Support, PCB
I work across four service areas, each delivered with full attention.
Discord and Telegram community management for NFT, crypto, and Web3 projects. Active moderation, spam removal, bot setup, and dai...
Informazioni su questo servizio
A poorly laid out PCB means failed prototypes, expensive respins, and delayed production. Getting it right the first time requires more than just placing components it requires signal integrity, clean routing, and files a manufacturer can actually use.
I design single, double, and multilayer PCB layouts and schematics using KiCad, EasyEDA, Altium Designer, and Eagle manufactured-ready for JLCPCB, PCBWay, and other fab houses.
What I can design:
- Single, double, and multilayer PCB layouts
- Schematic design and capture
- Microcontroller-based boards ESP32, STM32, Arduino, ATmega, nRF, Raspberry Pi
- IoT and wireless designs WiFi, BLE, LoRa, GSM, LTE
- Power electronics DC-DC converters, battery charging circuits
- RF PCB and antenna design
- Custom board shapes and enclosure-fit layouts
What you receive:
- Gerber files ready for manufacturing
- BOM Bill of Materials
- Schematic PDF
- 3D STEP file
- Source files in your chosen software
- ERC and DRC verified files
- Full manufacturing support guidance
Contact me before ordering to discuss your schematic, component count, and board complexity so I can confirm scope and delivery time.
Il mio portfolio
FAQ
1. Should I contact you before ordering?
Yes. Every PCB project is different in component count, layer stack, and complexity. Message me first so I can review your schematic or circuit idea and confirm the right package before any order is placed.
2. What software do you work in?
KiCad, EasyEDA, Altium Designer, and Eagle. Tell me your preference and I will deliver native source files in that software.
3. Are the files ready for JLCPCB or PCBWay?
Yes. All Gerber files are generated and verified to JLCPCB and PCBWay specifications. BOM and centroid files for assembly are included on request.
4. What if I only have a hand-drawn circuit or rough idea?
That is fine. A hand-drawn schematic, block diagram, or description of the circuit is enough to start. I will create the full schematic from it before moving to layout.
5. Do you perform DRC and ERC checks?
Yes. Every board goes through Design Rule Check and Electrical Rule Check before delivery to catch errors before manufacturing.
6. Can you support me through the manufacturing process?
Yes. I can guide you through submitting files to the fab house, reviewing quotes, and resolving any manufacturer queries after delivery.
